"BATTERY CARE"

GENERAL INFORMATION:

Each Cell (1S) = 3.7V
2 Cells in series (2S) = 7.4V
3 Cells in series (3S) = 11.1V

Maximum charging voltage per Cell is 4.16V. Any voltage per Cell above these ranges will damage the Cell.
Maximum charging current is 1C per Cell. 1C is one time of the capacity of the Cell, e.g. if the Cell is 1500 mAh, the charging rate
would be 1.5A. Any higher current will damage or shorten the lifespan of the Cell.
Minimum discharge voltage is 3.0V per Cell. Do not discharge the Cell below the voltage listed to prevent any damage or shorten the
lifespan of the Cell.

DISCHARGE RATE:

4C (4x the capacity of the Cell) is recommended for most Cells. 8C for HD (heavy duty version). Please check with your supplier for
further information.

SAFETY OPERATION:

Only use chargers which are specifically designed for Li-Poly and Li-ion batteries.
Set the charger properly for the number of Cell selection.
Set the charger properly for the proper current setting.
DO NOT charge the batteries inside the model, a car or anywhere near flammable material. Bare cement floor is highly recommended.
Never leave Cell(s) in charging unattended.
Always inspect Cell(s) for damage, especially after a crash. Discard the pack outdoors if there is any sign of leakage or swelling.
Keep the Cell(s) in a cool and dry place and out of the reach of children.

LIABILITY:

Since these batteries are considered an experimental product, the buyer should understand the risk and will take the necessary precaution for safe operation.
The supplier is NOT responsible for any damage, injury or death that resulted due to damage Cell(s), charger failure, wrong charger setting or other mishandling.

WARRANTY:

There is no warranty on Li-Poly and Li-ion batteries as the use of these batteries in R/C modeling is beyond the intended application of the manufacture.

For More Information About Li-Polymer See: http://en.wikipedia.org/wiki/Lithium_polymer

For More Information About Li-ion See: http://en.wikipedia.org/wiki/Lithium_ion_battery

PARKER MODEL LTD.
PARKERMODEL@ROGERS.COM